About Gregersen

Description

Responsible For A Fiat 500 Replacement Key Cost Budget? 12 Top Notch Ways To Spend Your Money
Fiat 500 Replacement Key Fob

It might be time to replace the battery if your 500 remote key fob isn't working. If you replace the battery and it still doesn't work it could be the issue elsewhere.

At United Locksmith, we specialize in the creation of new keys for old cars. We have the tools as well as the parts needed for this service.

Dead Coin Battery

A dead battery is the most common cause of your Fiat 500 keyfob not locking or unlocking the doors. The battery of the coin cell inside the key fob can be depleted quickly in the event that you don't use it frequently enough. If your remote has started to show signs like a loss of range or has stopped functioning, then the battery may be dead.

Metal clips keep the battery in within the key fob. If the clips aren't tight enough, it can cause problems with contact, which can prevent your remote from receiving power. Utilizing a small screwdriver, push the clip that holds the retaining pin open to take out the battery, and replace it with a brand new one. Make sure you use an alternative battery that has the same kind of voltage, the same size and specifications as the original battery.

The key fob can also become corroded or damaged by exposure to water. Even a small bath in soapy water could harm the electronic chip in. Keep your key fob dry.

Water Damage

If your key fob isn't operating correctly, it could be due to water damage. The rubber seals on key fobs stop them from getting damaged by a tiny drizzle or splash of water. However, it is essential to keep the keys of your car away from the washing machine, the ocean and even the pool.


fiat punto key replacement has an electronic chip in it that sends a signal to your car's immobilizer system. The chip allows the 500 to start and lock. If it gets wet it will not function.

If you're interested in checking if your key fob is still working, you can clean the internal electronics with isopropyl or an electronic cleaner. However, it's better to purchase a replacement from a dealership instead of trying to repair the key fob which was submerged in salt water.

A replacement fob may cost you a little bit but it's far less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! You can also do it yourself in several easy steps. Just ensure you have the right battery type before you attempt to open your key fob. This is a job that's far simpler than it appears and you can find step-by-step directions on the internet for nearly any key fob for your car.

Faulty Chip

The chip inside the key fob communicates to your vehicle's immobiliser to ensure that the vehicle is able to start when the correct key is inserted. If the chip is damaged or corrupted in any way the car won't start.

A chip that is damaged can happen due to several reasons, but most commonly due to water damage or the battery being dead. It is best to hand over the repair to a professional locksmith, who will be able to replace the chip in a short time and at a an affordable cost.

If your key fob will not function after exposure to clean tap or rain water take it off the battery. Clean the electronic component using a paper towel. If the key fob still fails to work, it is likely an issue with the chip and is required to be replaced.

Some people will go to their dealer in order to get an entirely new Fiat fob. However, this can be costly. United Locksmith is the best choice if you are looking to have your Fiat keyfob repaired at a reasonable cost. We have the tools and knowledge necessary to fix your Fiat key fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs send signals up to 50 feet to the vehicle, which will open and close the doors (and start the vehicle for those with automatic transmissions). However, there are a few factors that could cause the fob to cease working. It could be due to a dead battery, water damage, worn buttons as well as a receiver module problem and signal interference, or a malfunctioning electronic chip.

If the fob is placed in a pocket that been subject to extreme trauma, such as falling on hard floor or getting washed in a washer, it may not be capable of communicating with the car's Body Control Module (BCM). The BCM is a security device which will only accept signals from genuine original keys.

You will need to replace the fob if this occurs. A professional locksmith can handle every aspect of the key replacement process, including programming a new one for your 500. They can even offer the fob cloned to work exactly like the original (and costs a fraction of the cost).